If you’re dealing with a leaky toilet, don’t panic. No matter what the cause of the leak is, there’s an easy fix for it. This article will walk through the most common causes of leaks in toilets and how to repair them.
A leaking toilet can be a nuisance and cause water to seep into your home. If you hear a leak when flushing your toilet, it may be time to replace the flapper.
A flapper is a rubber seal that sits between the tank and bowl of a toilet. It prevents water from escaping from the tank into the bowl when the toilet is not in use. When you flush the toilet, it lifts up and allows water from the tank to enter the bowl. The flapper then seals off again so water does not leak out of the tank when it is not being used for flushing.
If your flapper has worn out, it will not stay sealed properly, causing water to leak out of your tank and into your home.
The Fill Valve
If your toilet is leaking, the first thing to check is whether it’s coming from the fill valve. If you don’t know what a fill valve is, it’s that thing on top of your tank that lets water flow in and out of it.
The first step in replacing a fill valve is draining all of the water out of your tank so that you can get to work. The easiest way to do this is by turning off the shutoff valves under your toilet tank (and flushing). After that, remove any washers or screws holding down the old fill valve and pull up on it carefully—it should come right off! Next comes installing new hardware: You’ll want to put both washers back onto their respective bolts before tightening them down with pliers or wrenches as necessary
The Flush Valve Assembly
If you suspect that your toilet bowl is leaking, check for leaks around the base of your toilet. If water is seeping through the floor, this could be a sign that the flapper valve inside your tank has been damaged and needs replacing.
If water appears to be spilling from under your toilet, it’s likely that a seal has failed or broken on the flush valve assembly inside of it. This can lead to excessive water use and wasted energy costs if not repaired promptly.
Lastly, look at where each connection point meets in order to ensure there isn’t any leakage there as well.
A Loose Toilet
The first thing to do is check the toilet bolts. If they are loose, the water may be leaking from around them. Check them in both directions and tighten as needed.
If that doesn’t work, you may need a new wax ring or washers for your flange (the ring of metal that attaches itself to the floor). Either way, you’ll want to take off your tank; this will give you access to everything underneath it and make it much easier for you to fix.
Bad Wax Ring or Wax Seal
A wax ring or wax seal is a rubber seal that fits between the toilet and the floor. Wax rings are inexpensive, but they can be difficult to install. If you have a leak around your toilet, check to make sure that it isn’t coming from your wax ring—if so, it will need to be replaced (or at least reseated).
As you can see, toilet leaks can be caused by many different things. Some are easy to fix and some are not. If you have an older toilet that is more than 12-15 years old, it might be time to get a new one. If you have a leaky toilet, it is important that you know what is causing it so that you can fix the problem quickly. If left untreated, these leaks could cause flooding in your home or even damage to other areas of your home such as floors or ceilings!
If you need further help fixing your leaking toilet, you can call Rescue Plumber Inc. for help.
We’re the best plumbers in High Desert CA. We specialize in residential and commercial plumbing, including fixing leaks and clogs, installing new water heaters and faucets, repairing leaks from toilets and showers, unclogging drains, and more. Our expert technicians will respond quickly to your call (760) 241-3100.
Our company is readily available to offer services in areas such as Hesperia, Helendale, Victorville, Apple Valley, Jess Ranch, Spring Valley Lake, Adelanto, Barstow, Pinon Hills, Baldy Mesa, Lucerne Valley, Oak Hills, Phelan, Ca.